"Dead" Battery Lamp

Step 2 Wiring The Toroid

Take 2 same lengths of wire and fold them over together to find a center point. Put the wire through the toroid and start winding equally until you have a whole layer surrounded by the wire which should be around 10 winds. Now take 2 of the different colored wires, and cut them shorter so they're not so long. Strip them, twist them together and solder them.

Comments

[bobtrial]

Add the length of the wires IS "Take 2 same lengths of wire " Recommend "Take 2, 10(??} inch lengths of wire" Bob

[boullie]

That depends on the size of your toroid, just take enough to get 10 winds...