Introduction: Rc Plane Landeing Gear

Picture of Rc Plane Landeing Gear

so i just built a 3 channel park flyer using foam board from the dollar tree and when i was done the control serfeces hit the table so one thing led to another so i made landing gear for my micro parkflyer using only 1 cable tye and epoxy

Step 1: Building the Rear Landing Gear

Picture of Building the Rear Landing Gear

so building the rear landing skid is just zipping the tye till it makes the desired size and cut the end off around 3/8 and glue on the plane and fly

hope you enjoyed this project please comment for more instructables

Comments

quincy trott (author)2014-02-07

ps this plane is a scratch built that i made from a champ:p

J SquaredA (author)quincy trott2016-01-04

Hi I have a champ too and I wanted to take it apart and build a ft mighty mini speedster (http://flitetest.com/articles/ft-mighty-minis). From your experiences, how easy is it to take apart the champ & electronics and put it together again? Are the electronics all in one piece or separately attached? Thanks!

quincy trott (author)J SquaredA2016-01-06

Its really easy to take apart but i don't think that the champ electronics
will be enough power to fly the mini. But the electronics are all one piece except the motor, that just plugs right into the side. its really a cake walk.

About This Instructable

1,724views

11favorites

Bio: i build stuff and i do FTC & FRC robotics also i steampunk
More by quincy trott:rc plane landeing gearTRAXXAS 6X6ftc gopro mount
Add instructable to: