It shoots around 35-45ft. and has hi power... Enough to break open a battery cover on the screaming serpent sound module.
don't forget to rate.comment if you like it.
Step 1: Gather these parts (part list)
5 gray rods
3 yellow rods
48 blue rods
80 - 110 white rods
140 - 160 green rods
8 white connectors
98 blue connectors
7 green connectors
107 yellow connectors
8 red connectors
6 tan clips
30 y connectors
3 ball sockets
20 gray one-slot connectors
8 gray two-slot connectors
114 orange connectors
3 cut in half orange connectors
6 ball joints
10-20 blue spacers
5-15 silver spacers
I hope this helps
Step 2: Build the front barrel
2.and this is too
3.hope fully you wern't expecting any thing.:P' " '
5.put on all the extras.
6.a new part
7.attach both parts where the spacers are
9.get the part you built that looks like this...
10.and put it on here
12.get this part too
13.put it on here
15.slide it into the hole on the front.
Step 3: The foregrip
2.add yellow connectors on like this
3.connect the other part on as shone in the picture
4.slide some gray rods through the finished product
5.and attach it at the front notice how it hooks on the y connectors are fliped
6.and in the back its just normal.
you might think it wouldn't hold on strong but it dose
Step 4: On to the barrel/mag
2.different view note the ball joints and sockets coming off are for the trigger.
3.build all these they are for the mag
4.attach one of the parts
5.attach the other
6.get both parts that where just built and...
7.PUT THEM TOGETHER
end step 4!