Introduction: Servo Motor on Intel Edison

Picture of Servo Motor on Intel Edison

This is a quick Instructable, to show how simple it is to hook up peripherals

Step 1: Gather Parts

Picture of Gather Parts

You will need an Intel Edison with the Arduino breakout board , a servo motor, and a potentiometer. I'm using the Seeedstudio iot Grove Starter Kit.

Step 2: Download Software

Picture of Download Software

Download the Intel version of the Arduino software, from the Intel website. Along with the drivers (for windows users), one is on the Intel website. The last driver is the FTDI driver. Go to and download the vcp driver.

Step 3: Write and Load the Sketch

Picture of Write and Load the Sketch

Load the knob sketch, don't worry if you see orange error looking code as long as it ends with Transfer complete.

Step 4:

Picture of

Here it is in action,


About This Instructable




Bio: lost my arm at 18, now I'm hacking stuff for disabled people (or animals)
More by tankapotamus:Arduio biometric, or vioce controlled robotic handRobotic prosthetic hand  with claw or 3d printed handCheap Filament Spool Holder
Add instructable to: