Introduction: Shower Stall Remove and Replace 1 of 7

Remove old shower stall and install new shower stall. Cut water to house off or if there are cut off behind the tub cut it off there. Carefully remove the old tub and shower valve. Remove handle, and esuction plate. Cut old valve out from the back side wall Clean work area and begin prepping the new tub and shower valve for installation. Begin install putting the new tub and shower in place and solder together , then come back to the tub side of the faucet in install the tub a shower trim.


docrings (author)2011-05-28

Agreed.... make this ONE instructable, please. Unless you want to selfishly hog the "related" column with only your own instructables... But I doubt that was your reason..

Better to put each video on page 2, page 3, etc.

Awesome-aniac (author)2010-01-03

No, no, no.  Why would you not just make one instructable?

About This Instructable




Bio: These " How to" Plumbing videos are a must. Even if you feel you know everything there is to know about plumbing ... More »
More by plumberx:shower stall remove and replace 7 of 7shower stall remove and replace 6 of 7shower stall remove and replace 5 of 7
Add instructable to: