Instructables
Picture of support? needed?
I made it at Techshop
:)


A table, a drill press and a bunch of 
a mess
 
Remove these adsRemove these ads by Signing Up

Step 1: Find a good peace of playwood

Picture of Find a good peace of playwood

Step 2: Put the table up side down over the plywood and mark the perimeter

Picture of Put the table up side down over the plywood and mark the perimeter

Step 3: Go to table saw

Picture of Go to table saw

Step 4: Remove the extra material

Picture of Remove the extra material

Step 5: Put back the plywood over the table and screw it

Picture of Put back the plywood over the table and screw it

Step 6: Add two extra pieces of plywood where the tracks will be

Picture of Add two extra pieces of plywood where the tracks will be

Step 7: Adjust the saw for a exact cut

Picture of Adjust the saw for a exact cut

Step 8: Cut all tracks over the table

Picture of Cut all tracks over the table

Step 9: Quick clean up before put the table in place

Picture of Quick clean up before put the table in place

Step 10: Put the table in place

Picture of Put the table in place

Step 11: Put the tools over the table in the tracks

Picture of Put the tools over the table in the tracks
Done :)