Instructables
Turn a rubber band and a regular bic pen into a pretty hard shooting gun. 

all you will need

a bic pen
scissors
small rubber band





 
Remove these adsRemove these ads by Signing Up

Step 1: Cuttin

1. take apart the bic pen by removing the ink from the tube and pull off the cap from the tube.
2. cut the ink tube on the opposite side you write on. cut about a quater inch in and sepperate the 2 sides w// your teeth
it should look like the 2nd pic

Step 2: Cuttin again

now cut the outside tube just like you cut the ink tube & sepperate it a little w// your teeth

be sure to cut off the apped side w// your siccors

Step 3: Rubber bandin

now is the hard part . hook the rubberband to the ink tube at the part that we cut. then push the pen w// the rubber band connected into the tube far enough so only about half an inch is sticking out. now hook the rubber band on the bic tube like in the pic
Marlton2 years ago
Me and my friend made one, but it didn't fire. we made a new one and it fired once. I made one out of an all stainless steel design drawing pen, and it shot a steel BB at what I would guess is around 190 fps. nice design
oh, joy. oh, rapture. its the same crap we've seen over and over and over again.
you need a different picture because urs makes fun of god
I apologize for any offense you may have taken from this image. However, I wish to impress upon you, I mean no religious harm to anybody. This image is a parody and only a parody. But, I must ask you this, do you believe god has a sense of humor? P.S. Might I request that you reply with proper English
BILLCLINTON5 years ago
BE CAREFUL, THIS IS NOT A TOY.
BILLCLINTON6 years ago
YOU NEED TO GIVE MORE DETAILS ABOUT YOUR GUN, SOUNDS REALLY COOL, BUT IS IT FINISHED?
well just look up q tip shooter, its the exact same design, hell of a lot better... no offence to ya blondy (maker of instructAble)
Look at my micro pen gun here: http://www.instructables.com/id/Micro_quotGunquot/
It is 10 times more powerful than this design, and 10 times smaller!
Made one with a 12 inch section of carbon fiber arrow shaft and 5 industrial rubber bands using 6 inch long bamboo skewers. Who woulda guessed that a skewer can go all the way through your thumb. Penetrates to 200th page in phone book flippin sweet thanx alot
silverman337 years ago
its okay at first but shit at second
street1047 years ago
i made one it works really good the third time i tested it, i pulled the ink back too far and the tip came out of the tube and i shot my finger....owwww
did it leave any marks
yeah the piece of lead is stuck in my finger
blondy (author)  little man7 years ago
sometimes but not all the time
i've done that too but with a pencil. i think i hit a nerve because my finger went all tingly and a little numb.
blondy (author)  street1047 years ago
Ya, i've doe that a few too many times
pyroman4587 years ago
ok i just made this and if you want good results, use a pretty small rubber band
cody_rigby7 years ago
whats up guys
reeding7 years ago
these pictures ssuuUUUUuuuck!
Bad Donut7 years ago
These pics are too fuzzy.
comment
blondy (author)  paper warrior7 years ago
well arnt u funny
ha ha ha
blondy (author) 7 years ago
(removed by author or community request)
theRIAA blondy7 years ago
how old are you?
this is stupid!!!..............Comment LOL!?!?!?!?!