Picture of toilet paper tube airsoft gun silencer
Hello, this instructable is on my way of making a silencer for my kjw 1911a1.
Remove these adsRemove these ads by Signing Up

Step 1: Parts

Picture of Parts

1 Toilet paper tube
1 6x6 in. sheet of cardboard
1 Bottle of superglue
1 Scissors
1 Pencil
1 double sided tape



Step 2: Cutting circles

Picture of Cutting circles
Get your tube and trace out the diameter on to the cardboard four times. Cut them out and glue three of them together and save one

Step 3: Finishing

Picture of Finishing
2011-04-22 23.08.58.jpg
2011-04-22 23.28.36.jpg
2011-04-22 23.29.42.jpg
2011-04-22 23.30.15.jpg
2011-04-22 23.30.45.jpg
Now you make a hole in one end of the circle on the thicker one that fits snugly over the tip of your barrel and an even bigger hole in the thin one.You then put the thicker one in one end and glue it in. Make sure it fits snugly. Then you put the thin one in the other end and glue it in. 

Step 4: Putting it on

Picture of Putting it on

Step 5: Finish

Picture of Finish
Thats how you make a silencer out of a toilet paper tube for an airsoft gun.

Note: This is a MOCK silencer, it wont quiet your gun.
lhinkle3 years ago
mommy y is there a black thing on the toilet paper???? i dont know... BANG!!!! OOOOOOOOWWWWWWWWWWWW!!!!!!!!!!!!!!!!! mommy my hand hurts
lhinkle3 years ago
Hitman2274 years ago
Good job, but i would not reccomend taking it to a field (silencer) becuase if it takes a burst, your making a new one.
Mattonater (author)  Hitman2274 years ago
Yeah, I just built it for the bathroom contest and I didn't think it would turn out that good.
Haha... Bathroom assasin = ). It still tops those crappy paper silencers on this site.