Introduction: Workshop Insignia

Hi, Just wanted to share my brand new finished insignia, I'm programming to hang it outside my little workshop.

Step 1:

worked it with my alluminium technic (see my metal skull instructables).
the skull and bones (crossed hammers) were gold peinted.
The whole was acrylic-weathered.
done :)

Comments

author
nemo13 made it! (author)2015-01-17

voilà !

temp_450201413.jpgtemp_679083493.jpg
author
Kiteman made it! (author)2015-01-16

Did you take any photos of the build? This would be a really cool step-by-step instructable.

author
nemo13 made it! (author)nemo132015-01-16

yeah, I Know! this was not meant to be an instructable...so I did not take first steps pics :(

author
Kiteman made it! (author)Kiteman2015-01-17

I make it a habit, every time I make something, or do some sort of DIY project, I take photos, just in case.

author
jbriese1 made it! (author)2015-01-16

This is very, very cool

author
nemo13 made it! (author)nemo132015-01-16

Thanks :)

About This Instructable

563views

21favorites

License:

More by nemo13:Fidget Hand Spinner From Old Hard Drivemake a Bonsaï one cockpit to control them all
Add instructable to: