loading
8CommentsJoined December 13th, 2016

Tell us about yourself!

Complete Your Profile
  • Alfarouq commented on Euphy's instructable Polargraph Drawing Machine2 months ago
    Polargraph Drawing Machine

    hi there !!Sorry for distarbance .. but I've no more time to submet my tech.project , and you helped me so mutch "THANK YOU BRO" .. I've just the path of the vectoŕ and how to compelement it or make it the same ?!

    View Instructable »
  • Alfarouq commented on Euphy's instructable Polargraph Drawing Machine2 months ago
    Polargraph Drawing Machine

    If you use adafruit shield you must connect the tearms of each coil within same side example:1st chick the motor end tearms by ohm-meter to find where is the ends and the centertaps of the same coil.M1 has two input junctions you must put the ends of the same coil in this two junctions

    View Instructable »
  • Alfarouq followed Euphy2 months ago
      • Polargraph Drawing Machine
      • Linear Clock
      • Mechanical expanding cardboard lamp - This way up!
  • Alfarouq made the instructable Polargraph Drawing Machine2 months ago
    Polargraph Drawing Machine

    thanks I followed your instrctions .. There is small problem I faced The path is not good

    View Instructable »
  • Alfarouq commented on Euphy's instructable Polargraph Drawing Machine2 months ago
    Polargraph Drawing Machine

    I think I found my misstake .. also thank you for your help Some other quastions : # how to chose the location of the motor (R, L) m12 , m34 adafruit shield posision.#how clearfy the imag and how to use SVG for that

    ok I asume that there is somthing I missed .. Reder pixels after I select the area around the vector dosen't function propably

    I didn't find the RENDER VECTOR command I foud RENDER PIXELS, is it the same ?! And it dosen't function

    View Instructable »
  • Alfarouq made the instructable Polargraph Drawing Machine2 months ago
    Polargraph Drawing Machine

    OK!! What about : STP-59D3012 /22545 (stepper motor) Driver : adfruit shield I think it's 12V motor with 6 pins Can It be matched to gather?! What about the programme ?! If you help me I would be great happy with that .. because it's my final project to be graduated .Thank you again ?

    View Instructable »
  • Alfarouq commented on Euphy's instructable Polargraph Drawing Machine2 months ago
    Polargraph Drawing Machine

    hi there !!The program ( arduino source ) perfictly downloaded ... but my steppers didn't work I use 28BYJ-48 with ULN2003 The servo perfectly works ..I followed all the instructions that I found for definning the pins in configuration part What did I miss and how to fix it ?!! Thank you !!

    View Instructable »