Azraelsrebellion
- Date Joined:Apr 9, 2007
- Instructables:1
- Total Views:47,612
- Featured %:100%
- Subscribers:4
- Comments:4
Instructables 
Patches
Azraelsrebellion has not received any patches yet... send Azraelsrebellion a patch!
Comments
» The plexiglass was used as a support for the rod to pass through. It helps stabilize th…
» 1. Your metal isn't flat? How thick is your aluminum? Not supporting the central beam m…
» Thank you for the comment but this hardly the same thing! Chladni Plates work by the p…
» Well yes we have thought of that. The fact that I made the wave driver will be posted o…
» 1. Your metal isn't flat? How thick is your aluminum? Not supporting the central beam m…
» Thank you for the comment but this hardly the same thing! Chladni Plates work by the p…
» Well yes we have thought of that. The fact that I made the wave driver will be posted o…
Orangeboard
2
comments
|
Add Comment
|
Apr 25, 2007. 9:03 PMSvenrox
says:
If I used a good speaker, intact with the cone and all, would I have to remove the cone to build this wave driver? I think the center of the cone looks a bit different, kinda flat. How could I build the wave driver with a speaker like that? Thanks guys!
Thanks for sharing your project, and welcome to Instructables!
Let me know if you have any questions.
You've probably already found your way around, but in case you haven't seen these, here's a guided tour of Instructables and an Instructable for making Instructables.
Let me know if you have any questions.
You've probably already found your way around, but in case you haven't seen these, here's a guided tour of Instructables and an Instructable for making Instructables.
 |
