Tell us about yourself!
Sorry one last question. What tools did you use to carve this out? I'm trying to decide on a set to buy. I'd rather not spend $400 to start out with... any suggestions of good tools and sizes for this sort of project would be much appreciated. I'm normally a jeweller so this is something new for me... thanks again.
Very nice work. I was wondering (I'm a noob with woodworking.) Did I just need any wide format printer basically? I was also wondering what sort of paper you used and did you just tape it over the wood and start out with a light outline then take the paper off and decide on the depth etc..? I'd really like to give something like this a shot for fun I'm just worried about destroying the paper template mainly.