ChromationSystems
- Date Joined:Dec 23, 2009
- Instructables:19
- Total Views:209,127
- Featured %:42%
- Subscribers:63
- Answers:2
- Comments:36
2 Contest Entries
Instructables 
Achievements
Patches
from
cdawisconsin
from
ChromationSystems
Questions
Comments 1-10 of 35(view all)
» It was an oversight, since I had full size print of the side panels that I used. I amen…
» Yes it can easily hookup to a computer PSU, run +5v to the controller and configure the…
» This kit is no longer offered, a new improved version, DMX-512 LED Controller with LED …
» The oscillator starts and runs correctly, the oscillator capacitors were excluded to al…
» Hardware stores usually make you buy the whole sheet if they have to cut it, but they m…
» Of course, would need to change some of the measurements for the blocks on the inner wa…
» Its all in the ZIP file in step one, eagle files, schematic, source code, HEX files
» You don't have to buy anything to recreate this, the schematic and HEX file are in the …
» It may seem like that somewhere, writing this step was kinda confusing for me. So I wou…
» For limit switches I use the active low method, Shown Here. Just attach a wire from the…
» Yes it can easily hookup to a computer PSU, run +5v to the controller and configure the…
» This kit is no longer offered, a new improved version, DMX-512 LED Controller with LED …
» The oscillator starts and runs correctly, the oscillator capacitors were excluded to al…
» Hardware stores usually make you buy the whole sheet if they have to cut it, but they m…
» Of course, would need to change some of the measurements for the blocks on the inner wa…
» Its all in the ZIP file in step one, eagle files, schematic, source code, HEX files
» You don't have to buy anything to recreate this, the schematic and HEX file are in the …
» It may seem like that somewhere, writing this step was kinda confusing for me. So I wou…
» For limit switches I use the active low method, Shown Here. Just attach a wire from the…
Orangeboard
4
comments
|
Add Comment
|
Mar 11, 2011. 1:09 PMdonicamm
says:
What size are the motors in the kit you sell for DIY CNC? I am very interested in purchasing one from you, but I need to know if the motors are nema 23, nema 17 etc.
I can't find a NEMA size for them but they are
Body: 1-11/16" square x 1-5/16" H.
Shaft: 3/16" dia x 7/16"L flatted shaft.
The mounting bolts are 1.25" apart, square.
3.75 degree, 60 ohm
Body: 1-11/16" square x 1-5/16" H.
Shaft: 3/16" dia x 7/16"L flatted shaft.
The mounting bolts are 1.25" apart, square.
3.75 degree, 60 ohm
Dec 25, 2009. 5:30 AMInstructables Robot
says:
Hello! Welcome to Instructables! I am the Instructables Robot. My job is to alert you whenever someone leaves you a comment or sends you a private message. I spend most of my day sending email. I like sending email. You probably want to upload an image to your profile. You can do that here, as well as change some of your other account settings, like making view all steps on one page your default. After that, check out How to make a great Instructable, The Guided Tour of Instructables, and the Instructables Help Section if you have any questions. Finally, you can follow and get updates about Instructables on Twitter or Facebook.
 |
