With Instructables you can share what you make with the world, and tap into an ever-growing community of creative experts.
Graphic 8 Channel RGB LED Panels With DMX Control
Parallel Port 3 Axis CNC Driver, Opto-Isolated, Unipolar Steppers
8 Channel LED Controller v.3
10" x 10" LED Infinity Mirror
Aquarium Light LED Refit
Small, Effective Solder Fume Extractor
18" Round LED Infinity Mirror Kit
DMX-512 LED Controller with LED Display
Quick Key Adapter, 10 Button HID Keyboard
8x8 LED Array Multiplexed Infinity Mirror
Table Top Touchscreen MAME Arcade
Just tried it with most recent Freestyler X2, selected "Enttec Open DMX" from the device list, and "FT232R USB UART" from the other drop down. The device then started transmitting DMX. It defaulted to 50mS packets(slow), that can be lowered to 25mS - 30mS for faster packet rates.
FTDI USB Adapter Based DMX Transmitter With Isolation
Does Frestyler automatically recognize this, or are there some other steps to take in order for freestyler to communicate with it?
48 Channel Mono / 16 Channel RGB LED Controller
LED Infinity Mirror, 32 LEDs, Selectable Patterns, Quality Frame
LED Star Beam Clock
Arcade Button RGB LED Conversion
Can it do Milling of PCB's???
Hi Thx for this instructablehave a question. Is pin 18-25 joined by weld cuz in diagram pin 25 is not joined with 18-24
u should buy a burner or programmer to upload code to the chip through computeras this http://ram-e-shop.com/oscmax/catalog/product_info.php?products_id=2613
i think u should use a burner or programmer to upload code to your pic chipas this http://ram-e-shop.com/oscmax/catalog/product_info....
hello , y make it this driver board with pic 16f876a , y put it the code on pic and with kcam work just in one sens even i change direction, where is the problem?in hex?
40x RGB LED Controller with 8-bit PWM and Selectable Patterns
Glass and Oak Bookshelf
This is fantastic info. How do you know if you need cathode/anode; and how do you find out resistor or transistor value? Does it only go on ground wire? Or all 4 wires? Cannot wait to try this, will use it on an Ipac Ultimate IO board and need 16-32 buttons, so this will save a ton!
Nonagon Cabinet with Gecko Habitat
sir i have made your cnc driver and it works fine with kcam.is it support to mach3 ? i tried but didn't success. i used 6v 5amp power supply.my motors are 6volts so is it needs to connect power resistors? thank you for helping me.
Join 2 million + to receive instant DIY inspiration in your inbox.
Download our apps!
© 2016 Autodesk, Inc.