With Instructables you can share what you make with the world, and tap into an ever-growing community of creative experts.
3D Printed, Ultralight, 3-axis Modular Time-Lapse Motion Control System
It's a press on fit. Once you force it over the shaft, it will stay put. I used a workshop vice.
I purchased the same worm gears you recommended from SDP-SI.com. The inner diameter of the worm is slightly smaller than the shaft of the Nema 17 motor. What is the best way to attatch it to the shaft?
I use SDP-SI.com. Good luck.
I see in the picture of the PAN module two ball bearings. Are the placed either side of the gear?
Join 2 million + to receive instant DIY inspiration in your inbox.
Download our apps!
© 2016 Autodesk, Inc.