Edouard67
- Date Joined:Jan 21, 2009
- Instructables:1
- Total Views:3,382
- Comments:5
Instructables 
Patches
Edouard67 has not received any patches yet... send Edouard67 a patch!
Comments
» Hi, I attach the structure servo with small wire thru the servo arm and the L bracket.I…
» Yes, the "servo shield" I bought was "made in asia". I don't have the precise location.…
» Oups! (some details are only available in the "sketch" source file)Check for "#de…
» Thanks for comment!I didn't noticed there were so much shields http://shieldlist.org/I …
» Thanks for your comment !I haven’t tried a gigapan so far.As a *quick* patch, I suggest…
» Yes, the "servo shield" I bought was "made in asia". I don't have the precise location.…
» Oups! (some details are only available in the "sketch" source file)Check for "#de…
» Thanks for comment!I didn't noticed there were so much shields http://shieldlist.org/I …
» Thanks for your comment !I haven’t tried a gigapan so far.As a *quick* patch, I suggest…
Orangeboard
2
comments
|
Add Comment
|
Nov 24, 2011. 2:58 AMPymo
says:
You used a 16X1 LCD display, correct?
Could you use 16x2 without changing anything?
Could you use 16x2 without changing anything?
Nov 24, 2011. 10:40 AMEdouard67 (author)
says:
Yes you can use the sketch as-is.
The lcdMessage(...) function displays the full message on the line no.1 and the same message from the 8th position on the line no.2.
...
lcd.print(s);
lcd.setCursor(0, 1);
lcd.print(s+8);
...
This works on most LCD display without any change on the sketch.
The lcdMessage(...) function displays the full message on the line no.1 and the same message from the 8th position on the line no.2.
...
lcd.print(s);
lcd.setCursor(0, 1);
lcd.print(s+8);
...
This works on most LCD display without any change on the sketch.
 |
