Gene Hacker
- Date Joined:Jun 3, 2007
- Instructables:2
- Total Views:142,144
- Featured %:50%
- Subscribers:13
- Topics:1
- Comments:82
Instructables 
Achievements
Patches
Gene Hacker has not received any patches yet... send Gene Hacker a patch!
Forum Topics
Comments 1-10 of 72(view all)
» Where did you obtain the pumps and valves from?
» My circuit isn't working, the trimpot isn't adjusting the current output. Do you have a…
» "Using a multi-meter, measure the mV output and adjust the 100 ohm pot so that it is ju…
» Could you give me a link to the schematic to a DDL driver? Has your diode ever broken d…
» I use frosting because it is cheap, readily available, and easily 'erased.' I am still …
» Resistance to fluid flow. Have you handled this stuff before? Is it about as viscus as …
» What's its viscosity? I use frosting because it's cheap and a good test medium.
» I've played around with ROVs before, and the most important things you want are maneuve…
» Are there any air bubbles in the plastic? Could you pour some into a pipe to make a nic…
» If only you could burn junk mail to run a car...
» My circuit isn't working, the trimpot isn't adjusting the current output. Do you have a…
» "Using a multi-meter, measure the mV output and adjust the 100 ohm pot so that it is ju…
» Could you give me a link to the schematic to a DDL driver? Has your diode ever broken d…
» I use frosting because it is cheap, readily available, and easily 'erased.' I am still …
» Resistance to fluid flow. Have you handled this stuff before? Is it about as viscus as …
» What's its viscosity? I use frosting because it's cheap and a good test medium.
» I've played around with ROVs before, and the most important things you want are maneuve…
» Are there any air bubbles in the plastic? Could you pour some into a pipe to make a nic…
» If only you could burn junk mail to run a car...
Groups
Orangeboard
4
comments
|
Add Comment
|
Dec 5, 2007. 3:01 PMcowscankill
says:
so you gonna do it? post the potassium chlorate? i tried the other method, and...;et's say nothing went that well...
Dec 6, 2007. 8:41 AMGene Hacker (author)
says:
I am currently working on another project that does not involve it(3d printer). So no I am probably not going to yet. If you really want that compound so badly, learn chemistry.
Thanks for sharing your project, and welcome to Instructables!
Let me know if you have any questions.
You've probably already found your way around, but in case you haven't seen these, here's a guided tour of Instructables and an Instructable for making Instructables.
Let me know if you have any questions.
You've probably already found your way around, but in case you haven't seen these, here's a guided tour of Instructables and an Instructable for making Instructables.
 |
