Tell us about yourself!
Tools and Materials for Arduino
Welcome to Arduino
3D Printing Class
Hello Again, I have a problem, My DVD stepper motors getting too hot, it reaches 80C, I reduce the voltage using the potentiometer on stepper driver to the minimum possible but still motors getting hot. Please advise
Thanks a lot, I will do what you said. :)
Well Done, Could you please explain the calibration you have done for CD drive stepper motors ? what values did you use? Thanks heaps
I think because your NEMA 17 is working fine with al stepper drivers, it might be a problem with CD drive stepper motor wiring. you need to consider phases.
Hey Folks, I don't know how to find Arduino codes for this 3D printer, anybody knows how can i get them?Thanks
I believe that is a good starting point for exploring Bioprinting. Thanks heaps
You probably need to read about Tissue Engineering, the main parameter is to print a scaffold with high porosity that allows living cells to grow :)