With Instructables you can share what you make with the world, and tap into an ever-growing community of creative experts.
Tell us about yourself!
Tripods and Supports
Next Steps for Photography
Tools and Materials for Easy 3D Printing
Easy 3D Printing
Bike Fender Part 4: Multi-Part Design
Bike Fender Part 3: Integrating Hardware
Thanks for the reply Jon. I went back and looked at the hole for the hinge pin in the second half of the lock and I noticed I missed adding the 0.25 mm offset from the pin dimension. I fixed it and I will try another print. I think it will fit much better now.
The hinge mechanism is a bit tight, but I set Cura to "Draft" quality. I will try again using "Final" quality in Cura to see if this helps the hinge fit better.
Bottle Lock Part 3: 3D Printing with Support Structures
Fun project!Can't wait to print and test it!
Bottle Lock Part 2: Mechanical Assembly
Bottle Lock Part 1: Base Model
Thanks for the info Jon. I forgot to turn supports off in Cura so a support structure printed in the middle narrow section of my stamp. So I think that caused the "Lines on the Side of the Print" you pointed out.
Setup and Print
Printed on a Type A Machines Series 1 3D Printer.
This is what I have completed in Fusion 360.
Tools + Materials for 3D Printing
Intro to 3D Modeling
3D Printing Class
Join 2 million + to receive instant DIY inspiration in your inbox.
© 2016 Autodesk, Inc.