loading
2Comments

Tell us about yourself!

Complete Your Profile
  • JohnM452 commented on Phil B's instructable Curing 2-cycle engine problems3 months ago
    Curing 2-cycle engine problems

    Thanks Phil for the answer. I will have a look and see if I can find the link and run through it over the weekend. I have since found out that the 2 stroke oil is in fact synthetic so I have definitely mixed it wrong even though it is not marked on the bottle. I have since drained the tank and added the same amount of petrol again to bring the mix back to where it should be.regardsJohn

    View Instructable »
  • JohnM452 followed Phil B3 months ago
  • JohnM452 commented on Phil B's instructable Curing 2-cycle engine problems3 months ago
    Curing 2-cycle engine problems

    Hi Phil B, I am a newbie with very little knowledge of 2 stroke engines, just bought a new Hyundai 33 cc 2 stroke multi tool, every thing was fine on all the heads and then it just stopped. Got it going again but if i pull the accelerator trigger there is no power it slows down and stops. This is brand new so the only thing i can think of is the petrol /2 stroke oil mix. on the instructions it says 40:1 for synthetic and 20:1 for mineral. I bought new petrol and new 2 stroke garden oil that is green, its ingredients says mineral so I put it in at 20:1 was i right to do this and is this the problem?any help would be great before I contact the shop I bought it in and look like a fool if it is the petrol/2 stroke oil mixregardsJohn

    View Instructable »