Tell us about yourself!
Getting Started With Robots
i keep getting this errorpi@raspberrypi:~ $ sudo dpkg -i repetier_armel.debdpkg-deb: error: `repetier_armel.deb' is not a debian format archivedpkg: error processing archive repetier_armel.deb (--install): subprocess dpkg-deb --control returned error exit status 2Errors were encountered while processing:
3D Printing Class
How To Make A Raspberry Pi SuperComputer!
Ultra Low Cost 3D Scanner
Sonic Wave Recorder
very cool. I look forward to elearning from your experience I am looking to build a device which I hope to use this tech over using a webcam and image detection. And resources you can share on the subject would be greatly appreciated.
Air Assist / Vacuum Port for small engraver
Build your own 3d printer filament factory (Filament Extruder)
Turntable made of 100y old german oak
Synthesizing Conductive Nylon
How to turn Adunio-based robot arm into a 3D printer and iphone 6s into a PTZ camara
Complete newbie step by step, 3D printer with all parts lists
How to Make a Simple Motion Sensor Led Light (Revisited) (PIR)
DIY LED BULB: $20 for $10
Re-purposing an old Scanner into a Tabletop Saw
Salvaging Liquid Crystal Displays (LCDs)
How to make a printed circuit board (PCB) using the UV light LED method.
3D Printed Wireless iPhone Charger & Case
Super Cheap 3D Printer from CD-Rom Drives
Make Emergency Homemade Spare Key With TicTac Bottle Or Credit Card In 2 minutes
5 Ideas With Plastic Bottles