loading
3Instructables28,046Views14CommentsGreeceJoined May 27th, 2014
A physicist with good knowledge in electronics and programming.

Achievements

10K+ Views Earned a bronze medal
Contest Winner Runner Up in the Zip Tie Challenge
Show 1 More »
  • Lilium JSN commented on Lilium JSN's instructable Arduino Rework Station2 months ago
    Arduino Rework Station

    This is sketch_jan21a, you are obviously doing something wrong. Extract the .rar file, open sketch_feb07a1.ino, if you get a pop-up to create a folder for the sketch press "Yes".

    sketch_feb07a1.ino is not empty.

    View Instructable »
  • Lilium JSN commented on Lilium JSN's instructable Arduino Rework Station11 months ago
    Arduino Rework Station

    At the "REFLOW_STATE_MENU_STEP_RAMP" you set degrees (C) per second, not seconds per degrees. The minimum is 0.25C/sec.

    I was gonna make an automated PID calibration option with another two thermocouples into the bottom and top heater, but it needs a lot of work. Do not use ceramic heaters, it's harder to calibrate their PID because of bigger thermal capacity (colding/heating slower). Use halogen instead.

    At the "REFLOW_STATE_MENU_STEP_RAMP" you set degrees (C) per second, not seconds per degrees. The minimum is 1C/sec.

    View Instructable »
  • Lilium JSN commented on Lilium JSN's instructable Arduino Rework Station1 year ago
    Arduino Rework Station

    Did you use the right libraries and correct initiations for your sensor chip?

    View Instructable »