loading
2Comments

Tell us about yourself!

Complete Your Profile
  • LorenD1 commented on n314pc's instructable CNC Spirograph11 months ago
    CNC Spirograph

    Ok, I made a set but the teeth needed refinement. As you run the gear it easily slips out of the teeth with the contact angle set like it is shown on the picture. I have the files done and I can send out a copy in sketchup or cut2d if anyone wants them. Its not a great spirograph but it does work. I made the ring gear approximately the size of a sheet of paper. I plan on cutting another blank the same size, add magnets to the two so that the paper can be sandwiched in between and have a small box that will hold it all.

    View Instructable »
  • LorenD1 commented on n314pc's instructable CNC Spirograph11 months ago
    CNC Spirograph

    Hello. I have all the components to make this. However, it would sure be handy to get a copy of your files rather than reverse engineering. Any chance you would post this for us?

    View Instructable »