With Instructables you can share what you make with the world, and tap into an ever-growing community of creative experts.
Tell us about yourself!
That was my first trial, but doesn't work. But today i changed the wiring back to the wiring from hyperion wiki, with a 100R resistor, but the led's get no data and lit random. I measured the voltage between GPIO 18 an GND and compare it to a datasheet for ws2812b led's and my voltage is too low. Expected: blue 3.0-3.4, green 3.0-3.4 and red 2.0-2.2Measured: blue 0.224, green 0.231 and red 0.224Highest output voltage (white) is 0.28v.Is it possible that my Raspberry has a defect?
Hey,got some problems with my logic level converter. All wiring is correct and software is installed, but when i try to start it, the led's not lit. I checked all voltages. LV is 3.3v and HV is 5v, but the LV-Signal on TXI is 2.7v and the HV-Signal on TXO is 9v. That doesn't sound normal for a 3.3v to 5v converter, but its the first time i work something like this, so i don't know whats a normal output signal...Hardware:http://www.amazon.de/Channel-Converter-Bi-Directio...R-Pi 3LED's: WS2812b with My wiring is 3 parallel rows of LED's in series (current was to high for one parallel circuit).
Let your inbox help you discover our best projects, classes, and contests. Instructables will help you learn how to make anything!
© 2016 Autodesk, Inc.