MarcoGhelfino

Files can be downloaded in final step :)

I have just made the files downloadable above

Thank you, sent! :)

No problem, thank you

Obrigado!Vou enviá-lo por e-mail.:)

Thanks :'D

Thanks! I hope so :)

Sure, send me your email :)

That's always a good idea!Thanks:)

Yo recomendaría pegamento 'no more nails'. Aquí... https://www.amazon.es/UniBond-No-More-Nails-interiores/dp/B003UYTLY4/ref=sr_1_2?ie=UTF8&qid=1488989288&sr=8-2&keywords=no+more+nails Perdón mi español es malo!:)

They look awesome! Good job

It's printed on A4, also the very last page are the tusk pieces, if you wanted to use a different card or something.Model comes out to about 43cm tall

This is amazing! Well done!

Sure! I can only send it via email as of now, but I will upload it on the site some time in May. :)

This is so impressive, I really love it!

Thank you!

I made it myself, I have another instructable I made about it. Check out my instructables it's called "Stylish passive amplifier"Marco

Thank you, I am currently applying to university courses for engineering. I'll always love woodworking though!

The band saw only removed a couple millimetres. A 1/4" bit will probably half the overlap. It should however be enough if the wood you are using is reasonably light.

I used a floor standing band saw, the largest you need to cut is just over 5" (13.2cm) you would have to use a hand saw, it will be a little more difficult but its quite possible.If the slot is big enough to fit the length of the band saw there is more than enough room. (My mistake I will edit that to be 'length')Thank you very much :)

Thanks! An important point of you're going through with the project, you might want to allow a few extra degrees of pitch on the table too so the weight pulls it level, if not it may be unlevel. :)

Looks great!

Love it!

Thanks everyone!I've entered the props contest we'll see how it goes!

Love it! Nice Mjolnir!