With Instructables you can share what you make with the world, and tap into an ever-growing community of creative experts.
Tell us about yourself!
3D Printing Class
Yes, it was the stepper voltage. I had one stepper that the voltage was fluctuating all the time. Luckily I had an extra to replace it with. Hope this helps.
Thanks Steve, I'll try that. It did print a little better last night when I slowed travel speed down. But still was off set some. Thanks again.
New to 3D printing. I have a Folgers Tech Prusa i3. When trying to print , the base layer prints, then after about 6 or 7 layers the next layers start to print off to the right. This happens when I print using repetier and from sd card. Any help would be appreciated. Thank You!wouldappreciated
Join 2 million + to receive instant DIY inspiration in your inbox.
© 2016 Autodesk, Inc.