Tell us about yourself!
Tools + Materials
Easy 3D Printing Class
Tools + Materials for 3D Printing
Fusion 360 Orientation
3D Printing Class
Thats awesome dude!
Sorry misunderstanding I used 6-7 bottles and twisted it around the tow bar lots of times, I didn't make rope.
I am not sure how long because it changes depending on the width of you top but if you braid it normally 3strand and then using say 4-5 braiding those then I reckon it could.(if it is something delicate I would make it at least able to carry 10-20 kilograms more than necessary) BTW you should test with a small piece beforehand.
where the bluetooth connects to the amp, just replace with audio jack input
honey never goes off, honey has been found in ancient Egyptian tombs that is still edible. The honey and vinegar don't go off quickly but the other stuff does.
sweet car dude!
Exactly, NERDS FOR THE WIN!!!(upbeat musical crescendo)
Probably but I would just braid it a bit more just in case, I say this because using 6 bottles I managed to tow a car!
That is an amazing sword, I am a ameteur knife maker and personally, I prefer AUS8A steel but thats my opinion really
BTW I voted for this
How to Build a Micro Racing Drone
Raspberry PI night vision goggles.