With Instructables you can share what you make with the world, and tap into an ever-growing community of creative experts.
The Bottle-abra Accent Light
How to Build an Open Air Doghouse:The Doggy Retreat
Installing a Slate Backsplash - The Easy Way.
Refurbish Your Water Softener and Save Big $$$
The Acrylic Scorpion
How to Grill a Cheeseburger or Hamburger
Delicious BBQ: Fall Off the Bone Beef Ribs
How to BBQ Chicken: Missourri Style
Garden Version 2.0
How to Build Your Pop Diva Her Own Stage
How to Build a $10 Bicycle Whip Light: Be seen and be safe
thank you very much for these instructions, very easy to follow....been lookin for beef ribs all over, finally found a large rack they usually cut into "short ribs"....so excited to try this on fathers day.....
The Bio-Battery - Power for the future. (So easy a 10 year old can do it.)
Just to note so misinformation is not propagated, air and liquid are VERY different in terms of failure mode. As liquid is incompressible, failure of a liquid-filled pressure vessel is very different and relatively benign compared to the failure of an air-filled pressure vessel. Air is compressible and therefore the failure of an air-filled pressure vessel looks a lot like an explosion. I have not studied the properties of PVC but would encourage anyone trying to build a pressure vessel from this material to consider safety first and not to disrespect air as a source of energy.
Thanks for this instructable. This worked for me on a 10 year old water softener. I was ready to throw out my Whirlpool after several years of not working (water pressure slowed to a halt even after doing routine maintenance). Saw this right before I was going to replace it. Tried it, working so far. A few things to add. The resin media bag now has a spout on one of the top corner so it should be easier to pour (found this out AFTER I poked a hole on the bottom opposite side). Be careful about spilling the resin out, those things are hard to clean up. The beads are slippery. And on mine (WHES40, but WHES20 and WHES30 have the same part) there's a plastic impeller assembly that can easily fall out when you tip the housing. It goes into the "out" side of the PVC with the impeller toward the housing side and the holder outside toward water flow. Good luck!! Thanks again for the instructable and saving me money!
How to Build a Custom Shelf Unit: Recycling at the same time
How is the gun holding up now after some years?
Project-Based Engineering for Kids
Recycling a PET bottle to a 20m long thread
Join 2 million + to receive instant DIY inspiration in your inbox.
Download our apps!
© 2016 Autodesk, Inc.