Tell us about yourself!
Hi SS If v rotate long time magnets will loss magnetism bcz of heat and no power develop ,wht shell v do,to gain loss magnetism for magnets
Hi can u suggest which type of ardunio uno I want to buy Because several types are present in online
How to programme this setep
Hi SSWhich grade magnet is better N-32;50;52
Height of coil can increase magnet height.
Inside diameter of coil should be greater or less than magnet,and height of coil can increase mag height.
ok if i want to produce 2kv with 9coils and 18 magnets which guage is better and number of turns required.thank q
thank u , if i arrange 12coil @16 magnets for 2kv@ 24v ,please suggest about guage number , and turns for coil.
if i want produce 2kv with 14 guage how many turns required for each coil ,and 16guage how many turns required.(total 9 coils).
HI ss iam doing 2kv turbine ,shell i use 50mm*25mm*10mm neodymium magnets ,is enough for 2kv watts producing ,,and which grade is best for turbine (i mean N32,N42,N50,N52 ......like ).if any changes should do or not.thanku
hi sir please replay all of my 4 question because I am doing this as my college project. 1. This my rough diagram arrangement of mag rotor,it is correct or any changes take place.(below)2.i want to wind 14# 3parallel wires 35 turns to produce 1500w and how many rpms should rotate to get 1.5kv, can u estimate how many amps can I get.3.and it can rotate 24hours, are any damage occurs.4.i am buying 12v luminous inverter with 1000w*2batter ,how much time will take full the charging.Please reply all of my 4questions because I am doing this as my college project. Thanks,.
hi sir, can u suggest diff b/w 24v and 48v. if i wind my turbine for 48v which guage wire should i use and how many turns i should turn , at which rpm i can get 1000w.