loading
5Comments

Tell us about yourself!

Complete Your Profile
  • NaveenI7 commented on sspence's instructable Arduino Load Cell / Scale3 months ago
    Arduino Load Cell / Scale

    I used arduino to power the hx711 circuit .My arduino was powered using USB cable.It shows 50 gms for 40 kg weight.

    I am using channel A.

    View Instructable »
  • NaveenI7 commented on sspence's instructable Arduino Load Cell / Scale3 months ago
    Arduino Load Cell / Scale

    Actually when I give pressure to one end of sensor ,weight increases but showing wrong weight.In rest position ,it shows zero value.

    Yes , it's a 4 wire load cell.Below is the link for imagehttp://www.gjimpex.co.in/load-cell-czl-601ac.htm

    View Instructable »
  • NaveenI7 commented on sspence's instructable Arduino Load Cell / Scale3 months ago
    Arduino Load Cell / Scale

    I am using hx711 with 200kg loadcell.This is my code but output is very bad even though I put a platform for weighing scale it shows zero weight.But when I give pressure it changes but to small extent.#include <hx711.h>// Hx711.SCK - pin #A0Hx711 scale(A1, A0);void setup() {Serial.begin(9600);}void loop() {Serial.print(scale.getGram(), 0);Serial.println(" g");delay(200);}

    View Instructable »