loading
3 Comments

Tell us about yourself!

Complete Your Profile
  • RyanB215 commented on mikey77's instructable Make Conductive Glue and Glue a Circuit4 months ago
    Make Conductive Glue and Glue a Circuit

    I needed to retrofit an LED into a plastic incandescent bulb socket. To small to solder, this worked well. I only had the aerosol liquid tape but it worked fine. Made it to a consistancy a bit thicker than water (lots of solvents in the aerosol variety) and used a toothpick to apply. First thin coat showed a tremendous amount of resistance variation from one end of the tape to the other. Applied a few more coats and added strands from a piece of 18AWG copper wire. The liquid tape was probably 2mm thick when done. Area was approximately 1x2cm. Worked like a charm, so many possibilities with this!

    View Instructable »