Tell us about yourself!
Could you post your PID values for your heated bed? I noticed that with a 12v supply, the heated bed only uses the heating element in half of the bed. This means that one side of the bed is slightly hotter than the thermistor reads and the other side is significantly cooler. By connecting to the 24v connections on the heated bed the entire bed is heated evenly, but has much less power and takes exceptionally longer to heat up. Do you think this is something that should be done or has using 12v connections directly heating half the bed works fine for your printing?
Delta Bot: DIY 3D Printer
Making rust powder for rocket fuel
Homemade liquid nitrogen generator
An SK450 Dead Cat Quadcopter to Call Your Own
Arduino WiFi Garage Door Opener
Programming the ATtiny
Wireless Mechanical Shutter Release
Quad Track Arduino Robot
Autonomous drone that you already have in your pocket!
Ultrasonic Range detector using Arduino and the SR04 Ultrasonic sensor
Portal Test Chamber Information Sign
Revised Project. 3 in one Universal screw tool.
Color Following AR Parrot Drone