2CommentsHammJoined July 12th, 2015
Kekse | MANGAS | Mediengestalter | :D | 14 | Junge | NRW | Glücklich Single
  • Strawberrymake1 commented on Vulcaman's instructable Cherry- 60€ 3D-Printer2 years ago
    Cherry- 60€ 3D-Printer

    You dont need to split it. You have two different 14A Rails on this PSU. Just wire all of the 12V Cables together, so you have one big 28A Rail. Then you just wire this one cable to the 11A and 5A connection of the RAMPS.BTW: These are the maximum recommended for the fuses. if your electronics(heatbed for example) take more than 11A or 5A for the electronics, its going to shut down. Because these high currents mostly will happen if there is a short circuit

    View Instructable »