TheGodsMustBeCrazy78
- Date Joined:May 21, 2007
- Instructables:1
- Total Views:48,605
- Featured %:100%
- Subscribers:7
- Comments:24
Instructables 
Patches
TheGodsMustBeCrazy78 has not received any patches yet... send TheGodsMustBeCrazy78 a patch!
Comments 1-10 of 22(view all)
» Your Schematics are a little out of focus, Can you get a better shot for us?
» One player comes to mind who excelled with this same handicap, Jerry Garcia! Dont give …
» You can find all the parts for under $50 even less if you scrounge around.
» Actually the pressure is never contained in the pvc, The ignition chamber is inside the…
» Thanks. I have a lot more projects if this one goes over well. I have been making all …
» I'm using a 6 volt relay, 12 volts doesn't seem to hurt it, it's only on a very short a…
» 600 to 1000 feet 5 oz water balloon, noise is not to bad.
» The relay should work unless the coil draws to much power and there is not enough to op…
» I took the one way valve off of a car vacuum system (Honda), I know it will hold up bec…
» I would use a coil, they have a higher amp output, you can boil water off the electrode…
» One player comes to mind who excelled with this same handicap, Jerry Garcia! Dont give …
» You can find all the parts for under $50 even less if you scrounge around.
» Actually the pressure is never contained in the pvc, The ignition chamber is inside the…
» Thanks. I have a lot more projects if this one goes over well. I have been making all …
» I'm using a 6 volt relay, 12 volts doesn't seem to hurt it, it's only on a very short a…
» 600 to 1000 feet 5 oz water balloon, noise is not to bad.
» The relay should work unless the coil draws to much power and there is not enough to op…
» I took the one way valve off of a car vacuum system (Honda), I know it will hold up bec…
» I would use a coil, they have a higher amp output, you can boil water off the electrode…
Groups
Orangeboard
4
comments
|
Add Comment
|
Thanks for sharing your project, and welcome to Instructables!
Let me know if you have any questions.
You've probably already found your way around, but in case you haven't seen these, here's a guided tour of Instructables and an Instructable for making Instructables.
Let me know if you have any questions.
You've probably already found your way around, but in case you haven't seen these, here's a guided tour of Instructables and an Instructable for making Instructables.
Jun 8, 2007. 7:48 PMTheGodsMustBeCrazy78 (author)
says:
Thanks, I hope to share some more soon. I wanted to know How I can send general invite for a collaborative project? I want to design a new instrument possibly stringed/percussive. I have a few drawings and plans for a basic mechanical prototype, This could take a few specialized individuals who would like to contribute their expertise. This is a great site! ! I Can Only Imagine....
You can send a more general invite for collaboration by posting in the forums.
 |
