loading
3 Comments

Tell us about yourself!

Complete Your Profile
  • VigneshK23 followed tonll10 months ago
  • DIY Bend Sensor (Using only Conductive Bags and Masking Tape)

    I'm sorry but I don't get you properly. I'll just elaborate ny problem. I'm doing the sensors for a sign language translator glove. I'm testing it using Arduino uno. I connected the sensor through a voltage divider circuit with a 15k resistor. I observed the ADC output on the serial monitor. For one trial, for a fully stretched finger, I got values from 360-400 . For a later trial, I got values in a different range for the same finger position. So that makes it difficult for me to fix the range of values for each finger position.

    *my problem

    View Instructable »
  • DIY Bend Sensor (Using only Conductive Bags and Masking Tape)

    I need some help regarding the calibration of the bend sensor. The change in resistance corresponding to each bend is there, but the value doesn't seem to be the same everytime. So eventually it becomes difficult for me to write the code. How do I overcome this problem? I'm using Arduino Uno for the testing.

    View Instructable »