Tell us about yourself!

Complete Your Profile
  • Getting Started with the ESP8266 ESP-12

    Yes I tried connecting RST-> VCC. But it was still giving repeated System ready messages.

    View Instructable »
  • Getting Started with the ESP8266 ESP-12

    Hi,I am not able to type any AT commands in Arduino Serial Monitor or in Putty. I am using 9600 baudrate.When I connect REST to GND, I see the messages [System Ready, Vendor:www.ai-thinker.com]. But I am not able sent any commands.This is my configuration. Tx of ESP8266 -> Rx of CP2102Rx of ESP8266 -> Tx of CP2102GND of ESP8266 & GND of CP2102 -> GND of LD33VVCC of ESP8266 -> VOut of LD33VGPIO15 -> GNDCH_PD -> VCCGPIO2 and GPIO0 -> VCCAny inputs on this will be much appreciated :)

    View Instructable »