alibenpuff's instructable
Tell us about yourself!
Complete Your ProfileAchievements
10K+
Views
Earned a bronze medal
1+
Featured Instructable
Earned a bronze medal
- alibenpuff commented on alibenpuff's instructable Make a Proper PCB Exposure Unit Out of a Cheap UV Nail Curing Lamp2 months ago
- alibenpuff favorited Magnetic Acrylic Rubik's Cube by gfixler2 years ago
- alibenpuff favorited Magnetic Rubik's Dice Cube by burzvingion2 years ago
The process is WAY better than using two acetates, and very simple to perform:Just tape your acetate to the lid of a container (could be a cookie can or similar, it just has to withstand acetone), so that the toner is exposed to the inside of the can, put an acetone drenched rag in the can and leave it closed in a sufficiently ventilated area (a.k.a. outside) for 30-60 minutes. Temperature should be high enough for the acetone to vaporize (>=20degC is fine, DON'T EVER HEAT IT UP!!). Keep in mind that this method will not work with every type of toner out there, but if it does, the results are usually excellent.