Tell us about yourself!
Sorry for the late delay. Try to fix the CC line first: (a) check that your midi source (keyboard?) is sending MIDI data to the box on the right channel (CH1 by default);(b) check the pin arduino is outputting CC voltages from (pin 9 by default);(c) check the CC data you have assigned your MIDI controller knob to (CC# 19 by default);(d) check your wirings.
Very nice instructable!Would it be possible to modify the library so that address pins could be user defined? Some of those you used by default are necessary for other modules to work (D0 and D1 are the serial receive and transmit pins Rx and Tx) so they are someway "wasted" to build up addresses bits.Thankyou!
Another MIDI to CV Box ...View Instructable »
Wye Box (audio Summing Box)View Instructable »
Jammarduino DUE - DIY PC to...View Instructable »
MattewH I am sorry but no matter what i try to do, after loading the sketch if i run a check of the "JoystickButton" example arduino returns 'Joystick' was not declared in this scope. I am using the 1.6.6 version of the IDE and the libraries are listed in the contributed libraries ... any hint?
aaaaand ... a few seconds later I had success! :)You have to select the Arduino Leonardo/micro board for the sketch to compile! Good to know ;)