bleachworthy
- Date Joined:Sep 18, 2006
- Instructables:5
- Total Views:123,249
- Subscribers:10
- Topics:3
- Comments:307
Instructables 
Patches
bleachworthy has not received any patches yet... send bleachworthy a patch!
Forum Topics
0
replies
Physics Illustrator on NON-tablet PC
posted 3 years ago
in Tech
last post by Brennn10
4 years ago
1
reply
instructables not showing up under sort by recent, or otherwise.
posted 4 years ago
in Tech
Comments 1-10 of 301(view all)
» Well, you can always try to file or grind a flat surface on the sides of the needle hea…
» Firstly, the air filter being dirty blocks air coming in, and will make the engine run …
» sorry it took so long, the only good way to tune it is to use WOT, I'm sure you can fi…
» blah, I need to read things right the first time... I'm assuming you have a diaphragm s…
» It's possible that your carb is plugged up a bit, mine does all the time, all you need …
» Look for an H or a L on the carb near the needle. I'll bet the needle is for high speed…
» I'll bet that smells wonderful!
» True, but you can also scale this project up a little, and use ball bearings (3-4 at a …
» This is a great idea! It would combine with another project I found years ago that uses…
» replace egg with cement filled handball/racquetball and then we can talk...
» Firstly, the air filter being dirty blocks air coming in, and will make the engine run …
» sorry it took so long, the only good way to tune it is to use WOT, I'm sure you can fi…
» blah, I need to read things right the first time... I'm assuming you have a diaphragm s…
» It's possible that your carb is plugged up a bit, mine does all the time, all you need …
» Look for an H or a L on the carb near the needle. I'll bet the needle is for high speed…
» I'll bet that smells wonderful!
» True, but you can also scale this project up a little, and use ball bearings (3-4 at a …
» This is a great idea! It would combine with another project I found years ago that uses…
» replace egg with cement filled handball/racquetball and then we can talk...
Orangeboard
2
comments
|
Add Comment
|
Thanks for sharing your project, and welcome to Instructables!
Let me know if you have any questions.
You've probably already found your way around, but in case you haven't seen these, here's a guided tour of Instructables and an Instructable for making Instructables.
Let me know if you have any questions.
You've probably already found your way around, but in case you haven't seen these, here's a guided tour of Instructables and an Instructable for making Instructables.
Jul 26, 2007. 9:08 PMbleachworthy (author)
says:
You're welcome, and thanks for the welcome, though i have been a member for ages. I just don't post alot of instructables, I have only made 3 of them. I loved the instructable on instructables, it helped me out a bit.
 |
