Tell us about yourself!
3D Printing Class
Thanks!That sounds like what I need.
I'm working on a similar design and added an override push button switch. It works but has issues I hope someone can help me with. I use GPIO 2 as input to sense the override switch so GPIO0 controls the relay. However if pin 0 can see gnd at startup it goes to programming mode. If I manually disconnect it during startup an then plug it in all is fine. My question is there a technique or device that would caus the pin to "float" for a short time ( milliseconds I'd guess) then connect?Thanks for any advice.
LEDs and Lighting Class