With Instructables you can share what you make with the world, and tap into an ever-growing community of creative experts.
PCB Quadrotor (Brushless)
Make your own Eco-friendly soldering flux
Micro 105 FPV Quadcopter - 3D Printed
T962A SMD Reflow Oven Fix/Hack
Raspberry Pi DIY
CNC Table & Storage
Build a Raspberry Pi-Powered Amazon Echo
How to Make Arduino Based Mini CNC Plotter Using DVD Drive
Wirelessly Control A Robot Using Arduino and RF Modules !
Comprehensive Guide to Electronic Breadboards: A Meta Instructable
uDuino: Very Low Cost Arduino Compatible Development Board
It works :)
DIY PORTABLE WORK STATION
Poor Man's 3D Printer
Wearable Electronics Class
Tools and Supplies
The transistors I am using have a slightly different pin layout. It's emitter, collector, base.
Ohhh. I'll try something a little less power-hungry. I didn't have a PN2222 or diode so I desoldered some similar components from an old alarm clock.
I'll give it a shot. :)
Well deserved :)
I know... a little scary ;) At least it only does so when instructed lol
Getting Started with Electronics
Conclusion & Going Further
Project: Infinity Mirror
Your First Experiments
I know kung fu!
I couldn't seem to get my motor spinning. I measured the Volts going from 0-5 with a multimeter. Maybe it requires too much current. I was using 1k ohm resistor and I tried both a C1815 and a C732 transistor. I read online that I might need a capacitor? The motor is a Radio Shack 273-0258 1.5-3VDC Metal Gear Motor. I tested the motor and it works... any ideas? These are the data sheets I found for the transistors and I'm assuming if volts go up and down on the multimeter that the circuit is working.http://www.futurlec.com/Transistors/C1815.shtmlhttp://www.futurlec.com/Transistors/2SC732.shtml
Also, forgot to say that I found this Kuman Arduino clone kit on Amazon and thusfar it's working great for following along with the early lessons. http://a.co/eKUjxfh
Really impressed with the quality of this class, the code samples, photos, simulators. Wow. Looking forward to building small robots in a few weeks :D
3D CNC Relief Sculpture - Fusion 360
Desktop CNC Setup + Operation
3D Milling CAM Setup - Fusion 360
3D CNC Relief Sculpture - ArtCAM
My computer was consistently unable to handle the CPU and memory intensity of this project. I used my work laptop and was able to complete it. Might suggest an alternate file for people with old machines ;)
Tools and Materials for Arduino
Welcome to Arduino
Basic Electronics Skills for Robotics
Getting Started with Robots
Tools + Materials for 3D Printing
Tools and Materials for CNC
Welcome to CNC
Raspberry Pi Class
Laser Cutting Class
3D Printing Class
Bike Fender Part 4: Multi-Part Design
Bike Fender Part 2: Using Parameters
Assembly and Finishing
This is a telescope focuser printed before I learned to calibrate my printer. I plan to try out the orbital sanding and epoxy finishing technique :)
Upgraded Z-axis rod on my 3D printer :)
After watching the Nut Pockets video and seeing without narration the steps to create the rear screw I felt like Neo in the Matrix when he receives his upload... "I know kung fu!"
Work in progress... started on my own using SketchUp before I heard about this class. Planning to port over into Fusion 360 and parameterize (is that a word?). Any tips on importing .skp?
Let your inbox help you discover our best projects, classes, and contests. Instructables will help you learn how to make anything!
© 2016 Autodesk, Inc.