With Instructables you can share what you make with the world, and tap into an ever-growing community of creative experts.
Tell us about yourself!
Used different printer, concentrated ethyl alcohol and nothing stuck to the board. I might try a 5:5 ratio just to see what happens. Other than that, Im out of ideas.
Going to use a different printer. I will post later with the results.
Step 2 dissolves the toner instantly. Alcohol is 70% by volume. I'm trying a 7:3 ratio to see what happens.
Same results. Going to use salt in alcohol to get rid of some of the water in it and try again.
Tried this last night. Bought Ethyl Alcohol from Walgreens and Acetone from Home Depot. Followed the instructions and at the end nothing stuck to the pcb. I usually use press and peel with an iron but prefer this method if I can get it to work. Any ideas?
Join 2 million + to receive instant DIY inspiration in your inbox.
© 2016 Autodesk, Inc.