With Instructables you can share what you make with the world, and tap into an ever-growing community of creative experts.
I tried to load it to 3dhubs, based on calculation there usually cost like that.
From above photo, it's already tight.But still need about maybe 30~60 degree tighter to near the expect place.It's 100% print , but looks got similar case like above comment that shrinked?
looks fine, my friend already running it with PLA.I am still waiting for the rubber bands from him.The only strange thing is outside bar & tip.The tips screw tight but not at the right place.
Waiting for long enough rubber bandsmaterial PLA (0.15mm layer height)printed by ATOM3dp 2.0
3D Printed Stepper Motor
Join 2 million + to receive instant DIY inspiration in your inbox.
© 2016 Autodesk, Inc.