loading
7 Comments

Tell us about yourself!

Complete Your Profile
  • dhb commented on JoshuaF98's instructable Portable CNC5 days ago
    Portable CNC

    This is when I wish I could read more than English.

    View Instructable »
  • dhb commented on theGHIZmo's instructable DIY Laser Engraver - Reference Board2 weeks ago
    DIY Laser Engraver - Reference Board

    Hi, theGHIZmo,I really appreciate your instructables on this laser engraver. I actually bought a GearBest engraver after reading them.I had no problems assembling the engraver with the help of your instuctables. I printed the reference board, no issues. Everything made sense to me until I reached step 4 of this instructable. I find the BenBox interface a bit confusing. Moving the image around over the grid and scaling it properly has prove to be quite a challenge to me. Deleting the grid after I'm done is something that I just cannot make happen. Would it be possible for you to coddle an old and slow person a bit and elaborate more on step four, especially what icons you use on the BenBox interface for step four. So far I have figured out most of them but however you accomplish step fou...see more »Hi, theGHIZmo,I really appreciate your instructables on this laser engraver. I actually bought a GearBest engraver after reading them.I had no problems assembling the engraver with the help of your instuctables. I printed the reference board, no issues. Everything made sense to me until I reached step 4 of this instructable. I find the BenBox interface a bit confusing. Moving the image around over the grid and scaling it properly has prove to be quite a challenge to me. Deleting the grid after I'm done is something that I just cannot make happen. Would it be possible for you to coddle an old and slow person a bit and elaborate more on step four, especially what icons you use on the BenBox interface for step four. So far I have figured out most of them but however you accomplish step four is just beyond me at the moment.Please know that you are very much appreciated!Dan

    View Instructable »
  • Arduino, Ten Turn Precision Potentiometer and MAX7219 Interface

    Thanks for your instructable. I managed to make it work through the serial monitor, however I cannot get the 7-segment display to work. I bought the MAX7291 module off e-bay and the pin-outs are printed different than the one you have in your instuctable. Your module in printed as VCC, DIN, LOAD, CLK and GND down the left side of the display. The module that I received is printed as VCC, GND, DIN, CS, and CLK. I tried my best to make it work but it does not. I checked ebay for a module printed as yours is but could not find one. I would be grateful if you could advise me on this. Thanks, Dan

    View Instructable »
  • dhb commented on eliesalame's instructable How to control LEDs using a remote control11 months ago
    How to control LEDs using a remote control

    Thank you for adding the sketch. It now works perfectly! This is a great instructable and you are wonderful!!!

    View Instructable »
  • dhb commented on eliesalame's instructable How to Control LEDs Using a Remote Control11 months ago
    How to Control LEDs Using a Remote Control

    What you are doing here is exactly what I need to do for a project I am working but for some reason I cannot make the sketch work (something about a function definition). Can you help me out by posting the sketch separately? I would really appreciate your help.

    View Instructable »