Tell us about yourself!
Oh I laughed when I saw how this is done. Great trick! I hope to build one with my daughter for a school project.
I think your smaller circle jig is the truly clever part of this. Thanks.
Thank you for such a clear and simple technique in your video. You as a woman also help me to reinforce for my girls that wood shop is for all.
So far, most of your loads are dc - cordless tools, computer. Would I seem smarmy if I suggested you investigate a dc/dc xfrmr and create a dc power tap off your battery bank? Yes, you’d need to kludge a dc connection for the tool battery charger, and a new cord to bypass the PC’s ac/dc inverter. But you’d avoid 2 stages of conversion losses.No, I haven’t done this. Your use of 12v lighting prodded the question into my head. It’s a nice project you’ve already done and this is only a question in case you get bored.
Large Motors Class
Cuts of Meat
Two Small Braids
Crossing Over Vs. Crossing Under
Single Braid Half Updo
Table Saw Class
Phil, cool idea. The converter can hide in your tool box until u need it for a cross cut.if you drill the hole first in a wider board - less chipping, easier to hold it - you can then rip the board and proceed with the rest of your neat design, making 2 converters at once.
You, sir, have some of the coolest hands-on instructables.
I like it! For the non-welders, consider replacing the rebar triangle with 1/2-5/8" ply. Then substitute a pair of gate hinges / pivots for the welded pivot points.
Clever, practical, and simple. This is a great example to help others figure out their own solutions. Thanks for sharing.