I have to reset the esp a lot... it doesn't seem to load the code on it correctly. I have to reset it often and it will randomly work. Once it works once, it'll keep going until you turn it off.. any ideas what might be causing this?
Hey. I started testing them and it seems to work when I upload the code but the more you reset/power cycle it.. the worse it gets. To a point where it won't even boot the code at all... unless you re-upload the sketch. I'm guessing the memory in the microcontroller might be faulty. I ordered a nodemcu dev board.. it has a ESP-12 on it. Gonna try my luck with that and see if the problem persists...
CNC Laser Cutter Journey
Edge 3D 3.0 - A $200 3D Printer
DIY Luxo Jr. Lamp (Pixar Inspired)
3D Miniature Chess Pieces made with a Laser Cutter
Small Pattern Welded "Damascus" Steel Kife (With NO power hammer)
16-Bit Wood Mosaic - Sonic!
Minion shoulder bags
A cantilevered foot bridge out of logs - with a hut!
250 quadcopter, full build
Easy PLA Removal of 3D Prints
How to bleach shirts with custom designs.
Legend of Zelda Bartop Arcade Cabinet
IPAD 7 - Insanely Powerful Arrow Driver
CO2 Laser Honeycomb Table Replacement
SAD Box inspired (keep ur soul warm with a light box)
Hardwood watch box
The Eldredge Knot
Solar USB Charger 2.0