gzip
- Date Joined:Jan 12, 2009
- Instructables:5
- Total Views:116,573
- Featured %:60%
- Subscribers:40
- Comments:51
Instructables 
Achievements
Patches
gzip has not received any patches yet... send gzip a patch!
Comments 1-10 of 51(view all)
» Breadboard jumpers are fine but a spool of wire (or even salvaged wire) is just as good.
» Yes, any Arduino will work.
» 1. Yes, that's possible.2. That depends largely on the components and power supply you …
» The levels are multiplexed. That means only one is lit at any given time but the cycle …
» That's a hardware problem, likely nothing to do with the cube. Make sure you have the r…
» Vice versa on 11 and 13.
» The example is configured (from bottom to top) as: byte levelPins[SIZE] = {11,12,13}; …
» And you're using the Arduino 1.0 software or older? I'm on Linux (Ubuntu) with 1.0 so I…
» That's strange. I wonder what's going on there. Is the #include missing to begin with …
» So even with the included example you need to import library before it compiles correctly?
» Yes, any Arduino will work.
» 1. Yes, that's possible.2. That depends largely on the components and power supply you …
» The levels are multiplexed. That means only one is lit at any given time but the cycle …
» That's a hardware problem, likely nothing to do with the cube. Make sure you have the r…
» Vice versa on 11 and 13.
» The example is configured (from bottom to top) as: byte levelPins[SIZE] = {11,12,13}; …
» And you're using the Arduino 1.0 software or older? I'm on Linux (Ubuntu) with 1.0 so I…
» That's strange. I wonder what's going on there. Is the #include missing to begin with …
» So even with the included example you need to import library before it compiles correctly?
Groups
Orangeboard
3
comments
|
Add Comment
|
Apr 9, 2011. 7:04 PMmini-lipe
says:
Hello, good evening, could you post the complete code that was used in its 3x3x3 LED CUBE? I found it very nice and wanted to do one too ... thanks, awaiting response!
Hi,
The software is linked in step 4:
http://www.instructables.com/id/LED-Cube-and-Arduino-Lib/step4/Using-the-Software/
The software is linked in step 4:
http://www.instructables.com/id/LED-Cube-and-Arduino-Lib/step4/Using-the-Software/
Apr 11, 2011. 4:20 PMmini-lipe
says:
Ahhh!! Thank you very much
I'll test it in my cube and I hope everything goes okay xD
Thanks anyway!
I'll test it in my cube and I hope everything goes okay xD
Thanks anyway!
 |
