ianhampton
- Date Joined:Jun 16, 2006
- Instructables:1
- Total Views:470,636
- Featured %:100%
- Subscribers:38
- Comments:17
Instructables 
Patches
from
kkbean
Comments 1-10 of 17(view all)
» That would depend on if you wished to display a 'classic smile' with or without a nose.…
» No, I think its actually that side just after the blank space where a second memory mod…
» I bought a 'Kingston Minifun' memory stick a few months back to do a follow up to this …
» I'm really doubtful of the whole overheat issue, commercial memory sticks are packed in…
» Yes, their only made of thin plastic...
» Good choice :) I messed up a few blocks removing the inside bits, crushing them with…
» Probably :)
» Because the drive would end up much bigger than it needs to be. Mine wasn't difficult t…
» Still working fine :) The heat is so minimal that I doubt the problem would ever arise.
» From memory I applied very small amounts of glue using tooth pick, so there was hardly…
» No, I think its actually that side just after the blank space where a second memory mod…
» I bought a 'Kingston Minifun' memory stick a few months back to do a follow up to this …
» I'm really doubtful of the whole overheat issue, commercial memory sticks are packed in…
» Yes, their only made of thin plastic...
» Good choice :) I messed up a few blocks removing the inside bits, crushing them with…
» Probably :)
» Because the drive would end up much bigger than it needs to be. Mine wasn't difficult t…
» Still working fine :) The heat is so minimal that I doubt the problem would ever arise.
» From memory I applied very small amounts of glue using tooth pick, so there was hardly…
