With Instructables you can share what you make with the world, and tap into an ever-growing community of creative experts.
Tell us about yourself!
I'm excited to finish this project however a little uncertain The other two red wires are soldered. I've been through the steps if you times and see where it requires is soldered to one of the sensor leads and a black 22 gauge wire is soldered to the 10 K resistor. I am completely new to these types of projects and since I am messing with electricity I want to be absolutely certain I don't mess up. I'm assuming one red wire is connected to the unused coil pin and another to the other end of the 10 K resistor where it's soldered to soldered to the relay. On an earlier step a ground was soldered to the open end of the 10k resister.
Join 2 million + to receive instant DIY inspiration in your inbox.
© 2016 Autodesk, Inc.