With Instructables you can share what you make with the world, and tap into an ever-growing community of creative experts.
Tell us about yourself!
Circuit Board Design Class
Table Saw Class
I also have gone to various worksite over the years only to find drawers full of broken and dull bits. Using two hex nuts side by side I always found to be the best way to let them check the angle. However perhaps JUDT as important I have also found that people get the angle right but do not remove enough material on the back side of the bit. The sharp edge needs to be the highest point that rides on the material to be cut. The back edge needs to low enough to clear the cut chip. You always know your angle and clearance is good when cutting metal particularly and a curly strip is seen continuous from the cut material
Let your inbox help you discover our best projects, classes, and contests. Instructables will help you learn how to make anything!
© 2016 Autodesk, Inc.